"Ask Me Anything": Ten Answers To Your Questions About Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a bit but it's still eye-catching. It might not be the plushest car in its class but it's a Ford Focus or Volkswagen Golf will isolate you even better from sloping surfaces - but it's a relaxed and a civilized drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will aid whether the issue is constant or intermittent.

Water Damage

If you accidentally drop your key fob into the puddle, or it gets wet while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry bag every time you are outside or perform activities that could expose it to excessive amounts water.

It's also important to make sure the fob has completely dried before you open it to use it again. If you detect any smells emanating from the fob like an industrial-like liquid smell or the scent of windshield washer fluid, this is another sign that it's been submerged in water.

A circuit board that is wet could cause the battery's charge to drop its charge, or even explode. If you can pull your keyfob 308 from the water you need to turn the button side up and shake as much water out as you can before opening the casing. After opening it, take out the battery and wipe the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote entry keyless system may not function include a dead coin-cell battery, receiver module problems, signal interference or a malfunctioning chip. If none of the above is the reason, you can reset the system by disconnecting 12 Volt battery from the vehicle for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to entering. This feature is extremely useful particularly in cold winter months. Remote start systems can stop working for a variety reasons, such as the battery being dead.

A coin-shaped battery found inside the key fob has a life span of two to four years, depending on how often it's used and the location where it was purchased. The date for use-by is typically printed on the package or listed in the instruction manual.

If the key fob is no longer functioning after being exposed to clean tapwater, remove the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it may have caused the chip to become damaged. It is recommended to replace it.

If you're not sure whether the battery is defective You can test its voltage with an instrument connected to the terminals for plus and minus. If the voltage is less than 12-13 volts then it is time to replace the battery. If you want to, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a few minutes and then reconnecting it in reverse order (positive cable first followed by negative). The engine should then start after this.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has created a fault. It's the part which sends out an alert when your key fob activates. It also functions as an alarm, and stops the car from starting without the correct key.

It could be due to several causes, such as water damage or simply getting old. If your Peugeot 308 key fob has been exposed to dirty tap water, for instance the chip that is located on the inside will be damaged. In this situation it is necessary to take the device apart and clean it thoroughly using isopropyl or electronic cleaner. Once the battery has dried then you can try again.

If the problem persists it is a good idea that you visit a local Peugeot expert or locksmith. They can employ an instrument for diagnosing to identify the issue and repair it.

The loss of your peugeot 208 replacement key cost keys to your car can be an emotional experience. However, a professional auto locksmith can fix the issue in a matter of minutes. They can program your vehicle and cut a brand new, working key for you. Click here to find a locksmith near you.

Faulty Electronic Chip

The electronic chip in the Peugeot Car Key Not Working (Jenkins-Bass.Hubstack.Net) 308 key fob plays a vital part in the remote control system. If it becomes damaged, your car might not start or you might receive a message stating "anti-theft active". If this occurs, the only way to fix the problem is to replace the key. Auto locksmiths with experience are able to offer the service within the shortest possible time.

The chip inside the key fob of your Peugeot 308 may become faulty for various reasons, including water damage, sweat or dirt. If your Peugeot key fob was exposed to soapy or dirty water, it should be cleaned immediately. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, allow the battery to completely dry.

Sometimes, a key fob can stop working because of radio interference. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. This could be due to unsafe conditions or objects that are within the vicinity of the vehicle. If you have this issue it is recommended to visit a Peugeot dealership.

The Peugeot Key Fob 207/308 is very delicate and requires special attention. It is essential not to drop or throw the key fob. If you lose something, try to locate it as soon as possible. You can reset the on-board computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative cable first, then the positive.